Lead2pass 2017 August New Cisco 300-165 Exam Dumps!
100% Free Download! 100% Pass Guaranteed!
Lead2pass is one of the leading exam preparation material providers. Its updated 300-165 braindumps in PDF can ensure most candidates pass the exam without too much effort. If you are struggling for the 300-165 exam, it will be a wise choice that get help from Lead2pass.
Following questions and answers are all new published by Cisco Official Exam Center: https://www.lead2pass.com/300-165.html
You create a checkpoint on a Cisco Nexus 7700 Series switch.
You plan to roll back the running configuration by using the checkpoint.
You must ensure that changes are made only if the entire rollback can be applied successfully.
Which rollback option should you use?
Which LISP component provides connectivity between LISP and non-LISP sites?
A. a map resolver
B. a proxy ETR
C. a proxy ITR
D. an ALT
Which command should you run to limit IS-IS LSP flooding on a network?
A. isis hello-padding
B. isis passive-interface
C. is-type level-1
D. isis mesh-group ISIS-MESH
You plan to configure authentication for OSPF.
In which mode should you configure OSPF authentication to use a specific key chain?
A. router ospf
B. global configuration
Which protocol is used to exchange MAC address reachability between OTV-enabled switches?
Which option must be enabled to implement manual MACsec?
A. CTS and dot1x
B. MSDP and dot1x
C. CTS and MSDP
D. CTS and private VLAN
Which implicit rules are applied to all IPv6 ACLs?
A. deny icmp any any nd-nadeny icmp any any nd-nspermit icmp any any router- advertisementpermit icmp any any router-solicitationdeny ipv6 any any
B. deny icmp any any router-advertisement logdeny icmp any a ny router-solicitation logdeny ipv6 any any log
C. deny icmp any any nd-na logdeny icmp any any nd-ns logdeny ipv6 any any log
D. permit icmp any any nd-napermit icmp any any nd-nspermit icmp any any router-advertisementpermit icmp any any router- solicitationdeny ipv6 any any
You have two Cisco Nexus 7700 Series switches named SwitchA and SwitchB.
You use the Rapid PVST+ protocol.
You must configure the switches as the STP root switches for VLANs 100 to 200.
Which command set should you run?
A. SwitchA(config)# spanning-tree vlan 100-200 priority 61440
SwitchB(config)# spanning- tree vlan 100-200 priority 61440
B. SwitchA(config-if)# spanning-tree guard root
SwitchB(config-if)# spanning-tree guard root
C. SwitchA(config-if)# spanning-tree cost 100
SwitchB(config-if)# spanning-tree cost 100
D. SwitchA(config)# spanning-tree vlan 100-200 root primary
SwitchB(config)# spanning- tree vlan 100-200 root secondary
Which statement accurately describes the implementation of FSPF on Cisco MDS 9700 Series switches?
A. FSPF is enabled on the Fibre Channel switches but must be enabled manually on a per-VSAN basis.
B. FSPF must be enabled manually on the switch and on each VSAN on the switch.
C. FSPF is enabled, by default, on the Fibre Channel switches for all VSANs.
D. FSPF is enabled on VSANs, but must be enabled manually on a per-FC switch basis.
Which option must be configured when you implement a vPC?
A. the CCL link, peer link, and vPC member interfaces
B. the peer keepalive link, peer link, and vPC member interfaces
C. the VSL link, peer link, and vPC member interfaces
D. the VSS link, peer link, and vPC member interfaces
Which statement accurately describes MP-BGP EVPN?
A. MP-BGP EVPN is a Layer 3 overlay alternative to VXLANs.
B. The control plane of the VXLAN overcomes the flood-and-learn limitations of MP-BGP EVPN.
C. The MP-BGP EVPN control plane overcomes the flood-and-learn limitations of the VXLAN.
D. MP-BGP EVPN is a Layer 2 overlay alternative to VXLANs.
You experience an issue on a Cisco Nexus 7700 Series switch.
You must gather detailed information about the system state and the configuration of the switch. Which command should you run?
A. switch# show logging > bootflash:Log.txt
B. switch# show tech-support > bootflash:Log.txt
C. switch# show running-config > bootflash:Log.txt
D. switch# show system > bootflash:Log.txt
Which two Nexus family line cards allow the configuration of features regarding LISP, OTV and MPLS? (Choose two.)
What are two ways to configure the switch ID for Cisco FabricPath? (Choose two.)
A. manually by using the vPC domain configuration
B. manually by using global configuration mode
C. dynamically by using the POAP protocol
D. dynamically by using the DRAP protocol
E. dynamically by using the SNMPv2 protocol
Refer to the exhibit. Which type of port channel was created?
switch# configure terminal
switch (config) # interface ethernet 1/4
switch (config-if) # switchport mode trunk
switch (config-if) # channel-group 1 mode active
Which GLBL load-balancing method ensures that a client is always mapped to the same virtual MAC address?
D. shortest-path and weighting
More free Lead2pass 300-165 exam new questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDSkhBVngxX0Z3Y0k
There is no doubt that Lead2pass is the top IT certificate exam material provider. All the braindumps are the latest and tested by senior Cisco lecturers and experts. Get the 300-165 exam braindumps in Lead2pass, and there would be no suspense to pass the exam.
2017 Cisco 300-165 (All 174 Q&As) exam dumps (PDF&VCE) from Lead2pass:
https://www.lead2pass.com/300-165.html [100% Exam Pass Guaranteed]
|One Time Purchase||✔||✖||✖||✖||✖|
|100% Pass Guarantee||✔||✖||✖||✖||✖|
|100% Money Back||✔||✖||✖||✖||✖|