Free Lead2pass Cisco 300-365 PDF Dumps With The Latest Update Exam Questions:
https://www.lead2pass.com/300-365.html
QUESTION 21
You have just added a new MSE to Prime Infrastructure and want to synchronize the MSE with your 5508 WLC. which is located behind a firewall in a DMZ.
You notice that NMSP messages are failing between the two devices.
What traffic needs to be allowed on the Firewall to ensure the MSE and WLC can communicate using NMSP?
A. UDP 16113
B. TCP 1613
C. TCP 16113
D. UDP 1613
Answer: C
QUESTION 22
When a Vocera badge performs a broadcast call in a properly configured VoWLAN using WLC v7.0, which two choices indicate how the QoS is marked? (Choose two.)
A. Upstream marked as Best Effort.
B. Upstream marked as ToS CS4.
C. Upstream marked as DSCP EF.
D. Downstream marked as DSCP EF.
E. Downstream marked as Best Effort.
F. Downstream marked as Silver.
Answer: CE
QUESTION 23
A network engineer is debugging issues with the mDNS gateway. Which type of reply should be seen in the Wireshark capture when querying for a mDNS service in the Bonjour Cache?
A. unicast from Prime Infrastructure
B. unicast from controller
C. multicast from devices
D. multicast from controller
E. unicast from devices
F. multicast from Prime Infrastructure
Answer: B
QUESTION 24
An engineer would like to capture NetFlowdata on PI. Which resource is required to allow this?
A. Cisco MSE as NetFlow exporter
B. Prime Infrastructure 1.0 or later
C. Cisco NAC as NetFlow exporter
D. Cisco ISE as NetFlow exporter
Answer: B
QUESTION 25
Which statement about when you configure FlexConnect APs and you want to set up Cisco Centralized Key Management fast roaming is true?
A. FlexConnect groups are required for Cisco Centralized Key Management fast roaming to work with FlexConnect access points.
B. APs that are in the same FlexConnect group but associated to different WLCs support Cisco Centralized Key Management.
C. Cisco Centralized Key Management fast roaming among FlexConnect and non- FlexConnect access points is supported.
D. The FlexConnect access point must be in standalone mode to support Cisco Centralized Key Management.
Answer: A
QUESTION 26
Refer to Exhibit.
A wireless client is connecting to FlexAPI which is currently working standalone mode.
The AAA authentication process is returning the following AVPs:
Tunnel-Private-Group-ld(81): 15
Tunnel-Medium-Type(65):IEEE-802(6)
Tunnel-Type(64): VLAN(13)
Which three behaviors will the client experience? (Choose three.)
A. While the AP is in standalone mode, the client will be placed in VLAN 15.
B. While the AP is in standalone mode, the client will be placed in VLAN 10.
C. When the AP transitions to connected mode, the client will be de-authenticated.
D. While the AP is in standalone mode, the client will be placed in VLAN 13.
E. When the AP is in connected mode, the client will be placed in VLAN 13.
F. When the AP transitions to connected mode the client will remain associated.
G. When the AP is in connected mode, the client will be placed in VLAN 15.
H. When the AP is in connected mode, the client will be placed in VLAN 10.
Answer: ADE
QUESTION 27
The customer has deployed C7960 phones with clients connected to them.
What switch feature could be enabled to distinguish IP voice traffic from client data traffic?
A. VoiceVLAN
B. QoS routing
C. WME
D. Weighted Queuing
E. QBSS
Answer: A
QUESTION 28
An engineer wants to configure Call Admission Control and ensure that AC is based on the capacity of the AP and considering the possible impact of other APs in the area.
Which two configuration options are required? (Choose two.)
A. StaticCAC
B. Admission Control
C. Load-Based AC
D. Add Traffic Stream
E. Reserved Roaming Bandwidth
F. Expedited Bandwidth
Answer: BC
QUESTION 29
A FlexConnect remote office deployment is using five 2702i APs indoors and two 1532i APs outdoors. When a code upgrade is performed and FlexConnect Smart AP Image Upgrade is leveraged, but no FlexConnect Master AP has been configured.
How many image transfers between the WLC and APs will occur?
A. 7
B. 1
C. 5
D. 2
Answer: D
QUESTION 30
What is the default NMSP echo interval between a Mobility Services Engine and Wireless LAN Controller?
A. 30Seconds
B. 15 Seconds
C. 10 Seconds
D. 60 Seconds
Answer: B
300-365 dumps full version (PDF&VCE): https://www.lead2pass.com/300-365.html
Large amount of free 300-365 exam questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDSnBMTGlieXBLZWs
Maybe you also need:
Large amount of free 300-360 exam questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDU1VGRGVieEdJWGM
Large amount of free 300-370 exam questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDSTdRZ3dTUjVscVU
Large amount of free 300-375 exam questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDaUxFbEpISnFINk0
