Free Download 400-201 Exam Dumps VCE From Lead2pass:
https://www.lead2pass.com/400-201.html
QUESTION 21
What IOS commands display MPLS label mapping on an LSR?
A. Show mpls ldp parameters
B. Show mpls ldp bindings
C. Show mpls forwading-table
D. Show mpls ldp discovery
E. Show mpls ldp neighbor detail
Answer: B
QUESTION 22
Drag and Drop Questions
Answer:
QUESTION 23
Refer to the exhibit. The vrf MAINT has been provisioned and used by the Service Provider management network. The engineer discovers that syslog messages are not being received on the syslog server. IP reachability has been validated using ping.
Which issue in the configuration must be corrected?
A. logging on must include the vrf MAINT keyword.
B. logging host must include the vrf MAINT keyword.
C. The logging facility must be configured for syslog processing.
D. The route targets that are configured do not match the route distinguisher.
Answer: B
Explanation:
http://www.cisco.com/c/en/us/td/docs/ios/12_2sr/12_2sra/feature/guide/srvrfslg.html#wp1059076
QUESTION 24
Which are the three header fields that affect how Equal-Cost Multipath hashes traffic flow into interface groups? (Choose three.)
A. source MAC address
B. source port
C. source IP address
D. destination IP address
E. IP protocol ID
F. destination MAC address
Answer: BCD
QUESTION 25
An R1 router requires an equal load balancing to reach the prefix 192.168.0.0/16 over two exit points: through R2 and R3 routers. Which two options must be configured on the R1 router to achieve this goal? (Choose two.)
A. The BGP maximum path feature must be configured on R1.
B. The BGP PIC core must be enabled on R1
C. Weight, local-pref, MED, as-path length, origin, and the BGP next-hop IGP cost must be the same for the R2 and R3 IBGP updates to R1.
D. The BGP Link Bandwidth feature must be applied on R1.
E. BGP extended community exchange must be enabled between IBGP neighbors.
Answer: AC
Explanation:
BGP link-bandwidth is for unequal-cost routes.
QUESTION 26
A company is deciding between an HVR and SVR solution in order to finalize a virtualization project proposal. Which is an advantage of a HVR solution versus a SVR solution?
A. A HVR solution implements dedicated data plane resources.
B. A HVR solution implements shared control plane resources.
C. A HVR solution introduces significant contention of resources.
D. A HVR solution implements dedicated chassis resources.
Answer: A
Explanation:
http://www.cisco.com/en/US/solutions/collateral/ns341/ns524/ns562/ns573/white_paper_c11-512753_ns573_Networking_Solutions_White_Paper.html
QUESTION 27
Which three of these are optical channel data unit (ODU) overhead fields? (Choose three)
A. general communication channel 0 (GCC0)
B. section monitoring
C. reserved (RES)
D. general communication channels 1 and 2 (GCC1 GCC2)
E. tandem connection monitoring activation deactivation (TCM ACT)
Answer: CDE
QUESTION 28
Which three modes are the operating of HDLC? (Choose three)
A. asynchronous balanced mode (ABM)
B. normal response mode (NRM)
C. normal peer mode (NPM)
D. asynchronous client mode (ACM)
E. asynchronous response mode (ARM)
Answer: ABE
Explanation:
Asynchronous response mode is an HDLC addition[1] for use over full-duplex links. While retaining the primary/secondary distinction, it allows the secondary to transmit at any time. Asynchronous balanced mode added the concept of a combined terminal which can act as both a primary and a secondary. There are some subtleties about this mode of operation; while many features of the protocol do not care whether they are in a command or response frame, some do, and the address field of a received frame must be examined to determine whether it contains a command (the address received is ours) or a response (the address received is that of the other terminal).
400-201 dumps full version (PDF&VCE): https://www.lead2pass.com/400-201.html
Large amount of free 400-201 exam questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDMExNMWJIYTlIcUU
